So you’ve spun up a Windows 2012R2 machine with Hyper-V installed and ready to go. However, now you’re stuck and not sure which type of Network Virtual Switch (vSwitch) applies to your environment(s)…
In Windows 2012R2, Hyper-V’s network virtual switch runs at Layer 2 (Data Link layer). If you are unfamiliar with this, or either terms, I suggest good old Wikipedia. 🙂 Layer 2 maintains a MAC address table contains the MAC addresses of all the virtual machines (VMs) connected to it. The switch determines where to direct/redirect the packets to based on MAC addresses. It should be noted, in Hyper-V, you can have an unlimited amount of VMs connected to this vSwitch.
In Hyper-V you have three types of Network Virtual Switches: External, Internal and Private. All have similar functions but are disgustingly different.
- External vSwitch allows communication between the VMs running within the Hyper-V hosts, the Hyper-V parent partition, and between all VMs on the remote host server. The External vSwitch does require a network adapter on the host (that is not mapped to any other Hyper-V External vSwitch). You can also tag to a VLAN ID.
- Internal vSwitch allows communication between all VMs that are connected to the vSwitch and also allows communication between the Hyper-V parent partition. You can also tag to a VLAN ID.
- Private vSwitch allows communication between all VMs that are connected to the vSwitch, and that is it. (Note, no communication between the VMs and its Hyper-V parent partition. Also no VLAN ID tagging can occur on the vSwitch)
Without the use of SCVMM (System Center Virtual Machine Manager), I have found there are two ways to go about creating a vSwitch, one via Hyper-V GUI and second via PowerShell.
Let’s start with the GUI:
Launch the Hyper-V console, and right-click on the Hypervisor’s Virtual Switch Manager. Now selecting New virtual network switch, you can specify your properties here. Name your vSwitch, associate to the correct vNIC, tag to the appropriate VLAN ID, etc.
You can now specify which vSwitch for your guest VM to use. Within the VMs properties, you will have the option to chose within the Virtual Switch (you will need to create a Network Adapter if not already done). Once selected you can specify your VLAN ID here. (I am finding you cannot specify the VLAN within the Management vSwitch, but it must be done on the client VM’s end) *Again, this is without the use of SCVMM..yet*
The same process above can be automated via PowerShell. If you’re like me and need to provision a few dozen Hyper-V hosts, creating vSwitches via the GUI is rather tedious. This can be automated with PowerShell (and SCVMM). Please see the code below:
First you will need to get a list of all the Network Adapters your Hyper-V host has to offer. Hopefully you have named them, if you have not, I highly suggest doing this, and considering this best practice and keeping your sanity.
Once you have the list of vNICs and their names, you can go ahead and start creating vSwitches.
If the code below worked (note only Line 6 is needed to create the External vSwitch) your Hyper-V host should have the vSwitch, or something similar: